Ball Transfers
Omtec's ball transfer system is so unique
they are patented in 21 of the top industrialized countries in the world!
Omtec
PBT Ball Transfer Strips
are designed for
easy drop in installation.		 Omtec Modular design
PBT Ball Transfer
Strips fit virtually
any roller conveyor. 		PBT Ball Transfer
Strips fit in between
or in place of rollers
in conveyor lines.
Pop up ball transfer and pop up positioner pad strips Omtec Work Bench Table Top Insert RollersTM
are ideal for use on Industrial Workbenches and Ergonomic Workstations!
Email Newsletter icon, E-mail Newsletter icon, Email List icon, E-mail List icon Sign up for our Email Newsletter

Pop up ball transfer strips
Ball Transfer and Pad Strips
Pop up postioner pad strips
At the flip of a switch, the PBT Ball Transfers raise the item to allow minimal effort orienting and positioning of an item. Retract the PBT Ball Transfers and PPD Positioner Pads below the conveyor rollers to allow items to move on the conveyor rollers unaffected by the Omtec Strips.

 
Omtec standard is to place the first and last pop up ball transfer 1.25 inches (31.75MM) C/L from each end of the main body (between frame dimension). The other pop ups are evenly spaced.

Omtec PBT Pop Up Ball Transfer Strips may be any length. The number of Pop Up Ball Transfers on a strip may be varied and, located on any center lines desired. The minimum center line is 2 inches (50.8mm).

Omtec PBT Ball transfers are pneumatic (air operated).

The air in feed line is a single 0.180 I.D. X 0.265 O.D. polyurethane tube under the strip between the first and last ball. The standard in feed tube supplied is 8 inches (203mm) long attached between the first and second ball, but can be any length or location on the strip desired.

Virtually any air control device may operate Omtec Pop Up Ball Transfer Strips. In the majority of applications simple non-electric foot and hand valves are used. The Omtec Pop Up Ball Transfer Unit uses very low air volume, it is usually not a consideration. Each up and down cycle of one ball uses .00038 cubic feet (.0000108 cubic meter).

If needed sensing device operation using electric solenoid valves may be used, control kits are available.


Home Page Put Omtec's field ingenuity to work for you.
Free support is only a phone call or email away! 		Email Omtec
*Covered under one or more U.S. and international patents. Copyright © 2000-2012 Omtec Corp.
181 Liberty Street, Marlboro, MA 01752 USA | Phone: (508) 481-3322 | Fax: (508) 460-0105

All images are the exclusive property of Omtec Corp. with all rights reserved.
Images may not be copied or reproduced without prior explicit permission of Omtec Corp.
1-1